Fire Safety and Hot Work

A makerspace has plenty of fuel (sawdust, wood, rags, finishes) and plenty of heat (welders, grinders, lasers, soldering irons, 3D printer hotends). This page covers the habits that keep those two apart.
Fire extinguishers
Fire extinguisher locations are pointed out during the New Member Orientation tour. Know where the nearest one is before you start work.
Never block an extinguisher, a fire lane, an electrical panel or a sprinkler head.
A class ABC extinguisher works on ordinary combustibles (wood, paper, cloth), flammable liquids and electrical fires. Use it with the PASS method: Pull the pin, Aim at the base of the fire, Squeeze the handle, Sweep side to side.
Only fight a fire that is small and contained, and only if you have a clear way out behind you. Otherwise get out and call 911. See Shop Safety: Emergency Information.
If you use an extinguisher, even briefly, report it so it can be recharged or replaced. See Shop Safety: Incident and Near-Miss Reporting.
To be confirmed: a list or floor plan of extinguisher locations, and which extinguisher types are in which areas.
Flammable liquids and finishes
Keep solvents, paints, stains and other flammable liquids closed when not in use, and store them in the flammables cabinet.
Do not use or store flammable liquids near welding, grinding or other sources of sparks or flame.
To be confirmed: where the flammables cabinet is and what may be stored in it.
Oily rags
Rags soaked with oil-based stains, linseed oil, tung oil and similar finishes can heat up and catch fire on their own as they dry. Never wad them up and toss them in the trash. Lay them out flat to dry outdoors or away from anything flammable, or put them in a closed metal container filled with water, before disposal. See Facility Operations: Trash, Recycling and Hazardous Waste.
Hot work: welding, cutting, plasma and grinding
Clear combustibles (sawdust, wood scraps, cardboard, rags) away from the work area before you strike an arc or start grinding. Sparks travel farther than you expect.
Watch the area for a while after you finish; smoldering material can flare up later.
Wear the PPE for the job. See Shop Safety: Personal Protective Equipment.
Hot work belongs in the Metal Shop. See Metal Shop: Metal Shop Overview.
Lasers and 3D printers
Never leave the laser unattended while it is running. This is posted on the machine. See Digital Fabrication: Laser Cutter.
Only cut materials that are safe for the laser. See Digital Fabrication: Laser-Safe and Prohibited Materials.
Electrical fire prevention
Overloaded cords and improvised plug adapters are a common cause of shop fires. See Shop Safety: Electrical Safety and Lockout/Tagout.